CBDLeCroy4434 create name base
CBDLeCroy4434 config name option value ...
CBDLeCroy4434 cget name
The CBDLeCroy4434 is intended to control a LeCroy 4434 scaler situated on a camac branch rooted in a VME crate by a CES CBD8210 branch driver. If you intend to utilize the driver in a camac crate controlled by a CCUSB, see the LeCroy4434 command. It provides the exact same functionality but understands the CCUSB to be its controller.
The CBDLeCroy4434 cannot be registered as a stack module by itself. Instead it must be registered first to a CBDCamacCrate. That CBDCamacCrate must then be registered to a CBDCamacBranch module. See the example below to understand how this works.
During initialization, all scalers are cleared and the auxiliary bus is disabled.
At the end of the run, no actions are taken.
During stack execution initiated by an event trigger, this driver will operate based on the following logic:
Read all channels
if "-incremental" is true
Clear the module
Just as a note, the latch and the clear are not atomic.
Specifies the slot of the CAMAC crate the target module is occupying. Default is 1.
Specifies whether to clear the scalers on each event after latching them. Default is false.
Example 1. Sample setup of a single scaler
CBDLeCroy4434 create sclr -slot 10
# Create a crate to stick it in
CBDCamacCrate create crate0 -crate 1
CBDCamacCrate config crate0 -modules [list sclr]
# Create a branch to register the crate in
CBDCamacBranch create branch0 -branch 0
CBDCamacBranch config branch0 -crates [list crate0]
Sets up a LeCroy 4434 scaler module in slot 10.